2026 Bentley Continental Alignment: Specs & Service

A 2026 Bentley Continental should track straight on a flat road with the steering wheel centered. Alignment angles can change after a major pothole impact or when suspension components are replaced. Bentley Boston in Wayland can measure all four wheels before recommending an adjustment.

• Vehicle pulls left or right on a flat road
• Steering wheel sits off center while driving straight
• One edge of a tire wears faster than the other

The service begins with an inspection of tires, steering, and suspension components that could prevent the alignment from holding. Current angles are measured against the factory specification, giving you information about whether adjustment is needed before paying for one. This process addresses the alignment angles that influence tire wear and steering position.

• Camber, caster, and toe measurement on all four wheels
• Adjustment toward manufacturer specification where possible
• Inspection for wear that could affect alignment

The manufacturer maintenance schedule for this model year has no alignment interval, so alignment service is generally condition-based. A check is sensible when tire wear, pulling, or steering position changes. Measuring the current angles can confirm whether adjustment is needed rather than assuming service is required.

• Consider a check every 2–3 years or 30,000 miles
• Check after suspension work
• Check after a major pothole impact or new alignment symptoms

An alignment measurement should be paired with an inspection of steering and suspension components. If a component is worn, adjusting the angles alone may not resolve the concern for long. Bentley Boston can identify conditions that affect alignment and explain whether an adjustment or additional repair is appropriate.

• Inspect tie rods for wear
• Check ball joints and strut condition
• Review tire and suspension wear before adjustment

Alignment measurement becomes more useful after a major pothole impact, suspension work, or a change in steering feel. Even wear and a centered steering wheel are helpful signs, but they do not replace a measurement when a concern exists. Booking service provides current angles before an adjustment is recommended.

• Look for even tread wear across each tire
• Notice whether the steering wheel remains centered
• Consider measurement after impact or suspension work

The service covers measurement of camber, caster, and toe on all four wheels, plus inspection of tires, steering, and suspension components. The angles are compared with manufacturer specification, and adjustment is made where the suspension allows. Contact the dealership at 508-978-7607 to arrange service.

• Location: 533 Boston Post Road, Rte 20
• City: Wayland, MA
• Phone: 508-978-7607

Inspection is important before any adjustment. Tires, steering components, and suspension parts with wear can hold the vehicle out of specification or cause the alignment to change again. A vehicle that pulls, has an off-center steering wheel, or wears one tire edge faster should be evaluated rather than corrected by guesswork.

Bentley Boston in Wayland, MA, can measure the current wheel angles and explain whether adjustment is needed. Bring your 2026 Bentley Continental to Bentley Boston in Wayland for a factory-spec alignment — schedule service.

Bentley Boston is located at 533 Boston Post Road, Rte 20, in Wayland, MA. The service checks camber, caster, and toe on all four wheels, along with tire, steering, and suspension condition. It provides a clear basis for deciding whether an adjustment is appropriate.

For directions or to arrange an appointment, call 508-978-7607 or visit Bentley Boston at 533 Boston Post Road, Rte 20, Wayland, MA 01778.